R8 Quattro Coupe V10-5.2L (BUJ) (2010)
CAUTION!
There is a risk of damaging the Selector Lever Transmission Range Display (Y5) circuit board.
Do not bend the Selector Lever Transmission Range Display (Y5) circuit board.
Do not touch electrical components and wires on the circuit board with fingers.
-
Carefully release the retaining tabs - arrow - on the cover molding one after another while carefully raising the Selector Lever Transmission
Range Display (Y5) - 2 - circuit board.
‹› The Selector Lever Transmission Range Display (Y5) can also be replaced completely with the cover molding, but the front center console must
also be removed for that.
Installing
‹› Tightening specifications. Refer to => [ Selector Mechanism, R Tronic Assembly Overview ] See: Manual Transmission/Transaxle/Gearshift
Actuating System - M/T/Service and Repair/Removal and Replacement/Controls, Housing/Description and Operation/Selector Mechanism, R
Tronic Assembly Overview.
Install in reverse order, paying attention to the following:
-
Carefully clip the Selector Lever Transmission Range Display (Y5) - 2 - circuit board onto the retaining tabs - arrow - on the cover molding.
-
Connect the electrical connector - 1 - for the Selector Lever Transmission Range Display (Y5) - 2 -.