R8 Quattro Coupe V10-5.2L (BUJ) (2010)
/Page-1129005.png)
-
Slide the return hose as far as the stop onto the master cylinder return connection - arrow -. Make sure the rubber grommet is seated correctly.
-
Remove Hose Clamps up to 25 mm dia. (3094).
-
Bleed the clutch system. Refer to => [ Clutch System, Manual Transmission, Bleeding ] See: Service and Repair/Procedures/Clutch System,
Manual Transmission, Bleeding.
-
Install the floor covering and driver side footrest cover.
-
Install the driver side instrument panel cover.
