R8 Quattro Coupe V10-5.2L (BUJ) (2010)
7
Clutch pedal mounting bracket
‹› Removing and installing, refer to => [ Clutch Pedal and Master Cylinder Mounting Bracket ] See: Removal and Installation/Clutch Pedal and
Master Cylinder Mounting Bracket
8
Bolt
9
End stop
‹› For clutch pedal
10
Nut
‹› 20 Nm
‹› quantity: 3
‹› For the mounting bracket to pedal bracket
‹› Self-locking
‹› Always replace
11
Clutch pedal
‹› Removing and installing, refer to => [ Clutch Pedal ] See: Removal and Installation/Clutch Pedal
12
Pivot pin
13
Bushings
14
Over-center spring
‹› Removing and installing, refer to => [ Over-Center Spring ] See: Removal and Installation/Over-Center Spring
‹› Observe installed location => [ Over-center spring installation
location: ] See: Removal and Installation/Over-Center Spring
15
Nut
‹› 22 Nm
‹› Self-locking
‹› Always replace
16
Mounting clip
‹› For master cylinder actuator rod
17
Oil seal
‹› Between master cylinder and mounting bracket