R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Tightening specifications, refer to => [ Lower Transverse Link with Retaining Bracket, Stabilizer Bar, Coupling Rod and Level Control System
Sensor Assembly Overview ] See: Steering and Suspension/Suspension/Control Arm/Service and Repair/Front Suspension/Lower Transverse Link
With Retaining Bracket, Stabilizer Bar, Coupling Rod and Level Control System Sensor Assembly Overview.
Tightening specifications, refer to => [ Wheel Bearing Housing and Wheel Bearing Unit Assembly Overview ] See: Steering and
Suspension/Suspension/Rear Knuckle/Service and Repair/Front Suspension.
-
Tighten the drive axle to wheel hub threaded connection, refer to => [ Threaded Connection Between Drive Axle and Wheel Hub, Loosening and
Tightening ] See: Axle Shaft Assembly/Constant Velocity Joint/Service and Repair/Removal and Replacement/Threaded Connection Between
Drive Axle and Wheel Hub, Loosening and Tightening.
-
On vehicles with electronically-controlled damping (Audi magnetic ride), reprogram the control position using the (VAS 5051B).
-
Axle alignment is required, see table. Refer to => [ When Vehicle Alignment is Necessary ] See: Maintenance/Alignment/Description and
Operation.