R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Installing
Installation is performed in the reverse order of removal. Observe the following when doing so:
‹› Bonded rubber bearings can only be turned to a limited extent. Only tighten suspension bolts when vehicle is in curb weight or control position.
‹› Wheel bearing, lifting to curb weight position on vehicles with coil springs. Refer to => [ Wheel Bearing, Lifting to Curb Weight Position ] See:
Procedures/Rear Suspension.
-
Tighten bolts - 1 -.
-
Pre-tighten the nut - 1 - to 8 Nm.