R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Fluid Line / Hose: Procedures
Transmission Oil Lines and Cooler, Cleaning
Special tools, testers and auxiliary items required
‹› Oil Collecting and Extracting Device (V.A.G 1782)
‹› Hose dia. approximately 18 mm
‹› Compressed air gun, commercially available
‹› Protective glasses
Procedure
-
Place the Oil Collecting and Extracting Device (V.A.G 1782) the separating joint.
-
Before installing a replacement transmission, always clean out the transmission oil lines and cooler with compressed air (maximum 10 bar).
‹› If heavily contamination in the transmission oil comes out, the transmission oil lines and cooler must also be flushed with clean transmission oil.
‹› Transmission fluid lines, removing and installing: front. Refer to => [ Front Transmission Oil Lines ] See: Removal and Replacement/Removal
and Installation/Front Transmission Oil Lines, rear => [ Rear Transmission Oil Lines ] See: Removal and Replacement/Removal and
Installation/Rear Transmission Oil Lines.