R8 Quattro Coupe V10-5.2L (BUJ) (2010)
‹› Only replace if damaged.
‹› Refer to => [ Connections on R Tronic Shift Actuator ] See: Shift Actuator - M/T/Service and Repair/Removal and Installation/Connections on
R Tronic Shift Actuator
5
Rubber grommet
‹› Replace
6
Hydraulic return hose
‹› Replace
CAUTION!
‹› Always follow the removal instructions.
‹› Refer to => [ Hydraulic Return Hose ] See: Service and Repair/Removal and Replacement/Controls, Housing/Removal and
Installation/Hydraulic Return Hose
7
Rubber grommet
‹› Replace
8
Bracket
‹› An auxiliary Ground (GND) connection is installed on the top left.
9
Heat shield
10
Bolt
‹› 10 Nm
11
Bolt
‹› 6 Nm
12
Transmission Hydraulic Pump (V387) motor
‹› Refer to => [ Transmission Hydraulic Pump Motor ] See: Hydraulic Pump - M/T/Service and Repair/Transmission Hydraulic Pump Motor
13
Connecting piece
14
Sponge
‹› Clean before reinstalling
15
O-ring
‹› Replace
16
O-ring
‹› Replace
17
Gasket
‹› Replace
18
Mechanical hydraulic pump
‹› Refer to => [ Mechanical Hydraulic Pump ] See: Hydraulic Pump - M/T/Service and Repair/Mechanical Hydraulic Pump
19
Bolt
‹› 5.5 Nm