R8 Quattro Coupe V10-5.2L (BUJ) (2010)
-
Disconnect the electrical connector - 2 - on the Hydraulic Pressure Sensor (G270).
‹› Disregard items - 1, 3, 4 and 5 -.
-
Remove the Hydraulic Pressure Sensor (G270) - 2 -.
‹› Disregard items - 1, 3, 4 and 5 -.
Installing
‹› Tightening specification. Refer to => [ Shift Actuator, R Tronic Assembly Overview ] See: Shift Actuator - M/T/Service and Repair/Description
and Operation.
Install in reverse order, paying attention to the following:
‹› Replace the seal.
-
Install the air filter housing.
-
Install the engine compartment trim.