R8 Quattro Coupe V10-5.2L (BUJ) (2010)
-
Disconnect the electrical connectors - 1 - on the Gear Recognition Sensor (G604).
-
Remove the bolts - 2 - and the Gear Recognition Sensor (G604) - 2 -.
Installing
‹› Tightening torque. Refer to => [ Shift Actuator, R Tronic Assembly Overview ] See: Actuators and Solenoids - M/T/Shift Actuator - M/T/Service
and Repair/Description and Operation, => [ Heat Shield Over the R tronic Shift Actuator,
Tightening Specifications ] See: Actuators and Solenoids - M/T/Shift Actuator - M/T/Service and Repair/Description and Operation.
‹› Replace O-ring.
‹› If the Gear Recognition Sensor (G604) with gold contacts is being replaced by a sensor with gold contacts, then the cable set for the sensor must
be replaced with the Adapter Wire Set (420 971 164). Refer to => [ Adapter Wire Sets, Gear Recognition Sensor 2 and Gear Recognition Sensor,
Installing ] See: Adapter Wire Sets, Gear Recognition Sensor 2 and Gear Recognition Sensor, Installing.