R8 Quattro Coupe V10-5.2L (BUJ) (2010)
must be replace (no interchanging). Both adapter wire harnesses must be installed. The Adapter Wire Set (420 971 164) generally has gold-plated
contacts on the connector - A -.
‹› Only gear recognition sensors with gold-plated contacts can be ordered.
‹› If a wiring harness or a connector for the gear recognition sensor on a vehicle built before VIN "WAUZZZ42_8N005581" is damaged, then a
different wiring harness, the Gear Recognition Sensor 2 (G616) and the Gear Recognition Sensor (G604) must be replaced.
Replace the adapter wiring sets:
-
Remove the rear bumper cover.
CAUTION!
There is a risk of injury. The pressure in the R tronic hydraulic system may be up to 50 bar.
‹› Always reduce system pressure first before working on the R tronic hydraulic system. Refer to => [ Hydraulic System, R Tronic,
Building System Pressure ] See: Gearshift Actuating System - M/T/Service and Repair/Procedures.
-
Body Protectors, Installing. Refer to => [ Body Protectors, Installing ] See: Service and Repair/Removal and Replacement/Body Protectors,
Installing.
-
Remove the left - 1 - and right - 3 - engine compartment trim.
-
Remove the engine cover - 2 -.
-
Remove the air filter housing.
-
Remove the air guide hoses - 1 - and - 6 - from the air filter housing.