R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Hydraulic Fluid Pressure Sensor / Switch - M/T: Service and Repair
Hydraulic Pressure Sensor
Removing
CAUTION!
There is a risk of injury. The pressure in the R tronic hydraulic system may be up to 50 bar.
‹› Always reduce system pressure first before working on the R tronic hydraulic system. Refer to => [ Hydraulic System, R Tronic,
Building System Pressure ] See: Gearshift Actuating System - M/T/Service and Repair/Procedures.
-
Body Protectors, Installing. Refer to => [ Body Protectors, Installing ] See: Service and Repair/Removal and Replacement/Body Protectors,
Installing.
-
Remove the left - 1 - and right - 3 - engine compartment trim.
-
Remove the engine cover - 2 -.
-
Remove the air filter housing.
CAUTION!
There is a risk of mixing up the electrical connectors.
‹› To prevent the electrical connectors on the gear selection valves and on the Hydraulic Pressure Sensor (G270) from getting mixed up,
mark them with colors. If the color marking is no longer visible, mark the electrical connectors before removal so they will not get
mixed up.