R8 Quattro Coupe V10-5.2L (BUJ) (2010)
-
Remove the bolt - 2 - and the Transmission Input Speed (Rpm) Sensor (G182) - 3 - from the transmission.
Installing
Install in reverse order, paying attention to the following:
-
Insert the Transmission Input Speed (RPM) Sensor (G182) - 3 - with a new O-ring.
-
Insert the bolt - 2 - with Sealing Paste (AMV 188 001 02) and tighten. Tightening specification => [ (Item 5) Bolt ] See: Service and
Repair/Removal and Replacement/Controls, Housing/Description and Operation/Reverse Gear Assembly Overview.
-
Connect connector - 1 -.
-
Tighten the heat shield bolts - arrows - to 10 Nm.