R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Installing
‹› Tightening specifications. Refer to => [ R Tronic Clutch Release Mechanism Assembly Overview ] See: Manual
Transmission/Transaxle/Gearshift Actuating System - M/T/Service and Repair/Removal and Replacement/Clutch.
Install in reverse order, paying attention to the following:
-
Secure the Clutch Position Sensor (G476) - 1 - on the bracket - 2 - with both bolts - arrows -.
-
Guide the Clutch Position Sensor (G476) wire through the opening on the transmission from below.
-
Carefully press the Clutch Position Sensor (G476) with the bracket onto the centering pins on the transmission.
‹› The two centering pins must be inside the transmission. Install them into the holes inside the transmission if necessary.
-
Tighten the bracket by hand first and then to the tightening specification on the transmission.
-
Install the transmission.