R8 Quattro Coupe V10-5.2L (BUJ) (2010)
-
Insert the adjustment ring.
-
Install the tapered roller bearing outer race all the way.
-
If necessary, replace the right flange shaft seal. Refer to => [ Right Flange Shaft Seal ] See: Seals and Gaskets/Service and Repair/Removal and
Installation/Right Flange Shaft Seal.
-
Press the flange shaft in => [ Installing ] See: Output Yoke/Flange/Service and Repair/Removal and Installation/Right Flange Shaft and install the
circlip.
-
Install the flange shaft with the final drive cover. Refer to => [ Final Drive Cover with Right Flange Shaft ] See: Transfer Case Cover/Service and
Repair.