R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Seals and Gaskets: Service and Repair
Right Flange Shaft Seal
Right Flange Shaft Seal
Special tools, testers and auxiliary items required
‹› Thrust Piece (T40007)
Procedure
-
Remove right flange shaft. Refer to => [ Right Flange Shaft ] See: Output Yoke/Flange/Service and Repair/Removal and Installation/Right Flange
Shaft.
-
Measure the installation depth of the current shaft seal to the outer edge of the final drive cover with a depth gauge and make a note of dimension -
a -.
-
Pry shaft seal out.
-
Lightly oil outer circumference of new shaft seal.
-
Press the new shaft seal in up to the dimension "a" that was measured using the Thrust Piece (T40007), measuring at several places on the
circumference.