R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Transfer Case Cover: Service and Repair
Final Drive Cover with Right Flange Shaft
Special tools, testers and auxiliary items required
‹› Oil Collecting and Extracting Device (V.A.G 1782)
Removing
-
Remove the air filter housing.
-
Remove the right drive axle heat shield => [ (Item 6) Heat shield ] See: Output Yoke/Flange/Service and Repair/Description and Operation/Shaft
Seal and Right Flange Shaft Assembly Overview.
-
Remove the catalytic converter bracket => [ (Item 8) Exhaust manifold with catalytic converter bracket ] See: Output Yoke/Flange/Service and
Repair/Description and Operation/Shaft Seal and Right Flange Shaft Assembly Overview.
-
Removing right drive axle.
-
Place the Used Oil Collecting and Extracting Device (V.A.G 1782) underneath and drain the transmission fluid - 1 -.
R tronic
-
Remove the hydraulic unit. Refer to => [ Hydraulic Unit ] See: Manual Transmission/Transaxle/Gearshift Actuating System - M/T/Hydraulic
Control Unit - M/T/Service and Repair/Removal and Installation.