R8 Quattro Coupe V10-5.2L (BUJ) (2010)
3
on the Mass Air Flow (MAF) Sensor 2 (G246)
5
on the Mass Air Flow (MAF) Sensor (G70)
-
Loosen hose clamps - 2 - and - 4 - and remove the air filter housing.
-
Remove the bolts - 1 - and the heat shield - arrow -.
-
Disconnect the electrical connectors - 1 - on the Gear Recognition Sensor 2 (G616).
-
Remove the bolts - 2 - and the Gear Recognition Sensor 2 (G616).
Installing
‹› Tightening torque. Refer to => [ Shift Actuator, R Tronic Assembly Overview ] See: Actuators and Solenoids - Transmission and
Drivetrain/Actuators and Solenoids - M/T/Shift Actuator - M/T/Service and Repair/Description and Operation, => [ Heat Shield Over the R tronic
Shift Actuator,
Tightening Specifications ] See: Actuators and Solenoids - Transmission and Drivetrain/Actuators and Solenoids - M/T/Shift Actuator - M/T/Service and
Repair/Description and Operation.
‹› Replace O-ring.
‹› If Gear Recognition Sensor 2 (G616) with gold contacts is being replaced by a sensor with gold contacts, then the cable set for the sensor must be
replaced with the Adapter Wire Set (420 971 164) and => [ Adapter Wire Sets, Gear Recognition Sensor 2 and Gear Recognition Sensor,
Installing ] See: Adapter Wire Sets, Gear Recognition Sensor 2 and Gear Recognition Sensor, Installing.