R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Liftgate Window Glass: Service and Repair
Rear Window
Rear Window
Special tools, testers and auxiliary items required
‹› Suction lifter (V.A.G 1344)
‹› Awl (V.A.G 1474/2) from the removal kit for flush bonded windows (V.A.G 1474B)
‹› Electric cutter (V.A.G 1561A)
‹› Angled blade (V.A.G 1561/10)
‹› Spooling tool (V.A.G 1654A)
‹› Cartridge heater (V.A.G 1939 A)
Special tools, testers and auxiliary items required
‹› Double cartridge gun (VAS 5237)
‹› Protective eyewear
‹› Leather gloves
Removing
Proceed as follows:
-
Remove the bottom center trim => [ Lower Center Trim ] .
-
Remove the right engine compartment trim => [ Left and Right Engine Compartment Trim ] See: Body and Frame/Access Cover/Service and
Repair/Left and Right Engine Compartment Trim.
-
Disconnect and free up the electrical connectors - 1 - and - 2 -.
-
Disconnect and free up the wiring harness to the engine compartment lid antennas.
-
Remove the right vent grille => [ Vent Grille ] .
‹› If the rear window will be installed again, secure the wiring harness to the side window with adhesive tape on the rear window to protect it from
damage - arrows -.