R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Window Track: Service and Repair
Front Window Guide
Front Window Guide
Removing
‹› The lower speaker is removed.
Proceed as follows:
-
Remove the door trim.
-
Remove the door seal and front interior window seal retaining knobs from the door shell => [ Door Seal and Inner Window Shaft Strip ] See:
Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Weatherstrip/Service and Repair/Door Seal and Inner Window Shaft Strip
.
-
Remove the nut - 2 - and bolt - 3 -.
-
Remove the front window guide - 1 - upward out of the door.
Installing
‹› Tightening specifications => [ Window Regulator Motor and Window Regulator Assembly Overview ] See: Window Regulator/Front Door
Window Regulator/Service and Repair/Window Regulator Motor and Window Regulator Assembly Overview.
Installation is reverse of removal, but note the following:
‹› When inserting the front window guide, make sure the exterior rearview mirror wiring harness is not damaged.
-
Insert the window guide - 1 - in the front door.
-
Tighten the nut - 2 - and bolt - 3 - by hand. The window guide must still be able to move slightly.
-
Adjust the door window => [ Door Window ] See: Window Glass/Front Door Window Glass/Service and Repair/Door Window, then tighten the
nut - 2 - and bolt - 3 -.