RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
Convertible Top Hydraulic Cylinder: Service and Repair
Hydraulic Cylinder, Removing and Installing (Page No 84)
Hydraulic Cylinder, Removing And Installing
Hydraulic lines, removing and installing.
Bracket drive motor cylinder
-
Remove bracket hydraulic cylinder - 1 - from ball sockets - 2 -.
-
Unclip hydraulic lines from brackets - 3 - (Qty. 6) and loosen cable ties - 4 - (Qty. 2).
-
Remove hydraulic lines and cylinders from convertible top frame and place them in convertible top compartment.
Convertible top compartment cover cylinder
NOTE: The convertible top compartment cover cylinder is installed as described above.
Main drive cylinder
-
Remove convertible top switch unit bolts - 1 -. The switch unit consists of Convertible Top Closed Position Switch F202 and Convertible Top
Open Position Switch F171.
-
Carefully remove convertible top switch unit from bolting point mounts.
-
Remove main hydraulic cylinder securing pins - 2 -.
-
Loosen nuts on main hydraulic cylinder bracket until they are removed from the center and can be stored in the vehicle.
-
Installation is reverse of removal.