RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
‹› The Camshaft Locating Tool (T40070) is correctly positioned when the holes for the cylinder head bolts remain free.
-
Install Crankshaft Holder (3242) in bore and tighten to 20 Nm.
‹› The Crankshaft Holder (3242) must engage in the locating hole of the crankshaft, otherwise repeat the adjustment.
-
Remove camshaft locating tools on both cylinder heads.
-
Remove Crankshaft Holder (3242).
-
Screw sealing plug of "TCD" marking with new sealing ring into upper section of oil pan. Refer to => [ Upper Oil Pan Section Assembly
Overview ] See: Engine Lubrication/Oil Pan/Service and Repair/Upper Oil Pan Section Assembly Overview.
The rest of the installation is in reverse order of removal, note the following:
-
Install left and right timing chain covers => [ Installing ] See: Timing Cover/Service and Repair/Left and Right Timing Chain Covers.
-
Install cylinder head covers: Left => [ Left Cylinder Head Cover ] See: Cylinder Head Assembly/Valve Cover/Service and Repair/Left Cylinder
Head Cover, right => [ Right Cylinder Head Cover ] See: Cylinder Head Assembly/Valve Cover/Service and Repair/Right Cylinder Head Cover.
Tightening specifications. Refer to => [ Camshaft Timing Chains, from 03.2007 Assembly Overview ] See: Camshaft Timing Chains, From 03.2007
Assembly Overview