RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
-
Install chain tensioner and tighten bolts - 2 -.
-
Press drive chain tensioner guide rail in direction of - arrow - and remove Locking Pin (T40071) from chain tensioner.
-
Install power take-off drive chain. Refer to => [ Power Take-Off Drive Chain ] See: Cylinder Block Assembly/Accessory Drive/Service and
Repair/Power Take-Off Drive Chain.
-
Install the camshaft timing chains. Refer to => [ Installing ] See: Camshaft Timing Chains, From 03.2007.
-
Install lower timing chain cover. Refer to => [ Lower Timing Chain Cover ] See: Timing Cover/Service and Repair/Lower Timing Chain Cover.
-
Install crankshaft seal, transmission side. Refer to => [ Crankshaft Seal, Transmission Side ] See: Seals and Gaskets/Crankshaft Main Bearing
Seal/Service and Repair.
-
Install oil filter housing. Refer to => [ Oil Filter Housing ] See: Engine Lubrication/Oil Cooler/Service and Repair/Oil Filter Housing.
-
Install intake manifold.
-
Install left and right timing chain covers => [ Installing ] See: Timing Cover/Service and Repair/Left and Right Timing Chain Covers.
-
Install cylinder head covers. Refer to: Left => [ Left Cylinder Head Cover ] See: Cylinder Head Assembly/Valve Cover/Service and Repair/Left
Cylinder Head Cover, right => [ Right Cylinder Head Cover ] See: Cylinder Head Assembly/Valve Cover/Service and Repair/Right Cylinder Head
Cover.
-
Install dual-mass flywheel. Refer to => [ Dual Mass Flywheel ] See: Transmission and Drivetrain/Flywheel/Service and Repair/Dual Mass
Flywheel.
-
Install clutch pressure plate.
-
After installing the engine, fill with oil and check the oil level.
Tightening specifications. Refer to => [ Timing Mechanism Drive Chain, from 03.2007 Assembly Overview ] See: Timing Mechanism Drive Chain,
From 03.2007 Assembly Overview