RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
/Page-903003.png)
CAUTION!
Make sure that no sealant residue enters the engine.
-
Clean sealing surfaces so they are completely free of any oil or grease.
-
Clean the old sealant from the holes - arrow - in the cylinder head gaskets.
‹› With the cylinder head installed only half of the holes in the cylinder head gasket are visible.
CAUTION!
Cylinder head gasket must not be kinked. A kinked cylinder head gasket must be replaced.
-
Bend the ends of the cylinder head gaskets very slightly downward - arrows - until the upper sealing surface of the gasket and cylinder head can
be cleaned.
