RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
Combination Switch: Service and Repair
Ignition Switch
Ignition Switch
Removing
-
Remove Steering Column Switch Module (SCSM). Refer to => [ Steering Column Switch Module ] See: Steering Column Switch Module.
-
Disconnect electrical harness connector at induction coil.
-
Disconnect electrical connector - 1 - at ignition switch.
-
Remove security coating from both screws - arrows -.
-
Loosen screws - arrows - slightly and remove ignition switch from steering lock housing - 2 -.
Installing
Install in reverse order of removal, observing the following:
‹› Make sure that ignition switch and lock cylinder are in same position,. "Ignition ON", when installing.
-
Secure screws - arrows - at steering lock housing - 2 - with security coating.
-
Install Steering Column Switch Module (SCSM).