RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
Specified value: 2.0 ohms Max.
If the specification was not obtained:
-
Check the wiring for a short circuit to each other, Battery (+), Ground (GND), or an open circuit.
-
Check the electrical harness connector for damage, corrosion, lose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is found in the wiring and the voltage supply OK:
-
Replace the Motronic Engine Control Module (ECM) (J623) or the Engine Control Module (ECM) 2 ( J624). Refer to => [ Engine Control
Module 1, Removing and Installing ] See: Service and Repair/Engine Control Module 1, Removing and Installing.
Final procedures
After repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Mode 03 - Read DTC Memory.
2. If necessary, erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Powertrain Management/Computers and
Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Mode 04 - Erase DTC Memory.
3. If the DTC memory was erased, generate readiness code. Refer to => [ Readiness Code ] See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes.
-
End of diagnosis.