RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
-
Position engine/transmission jack V.A.G 1383 A with universal transmission support V.A.G 1359/2 and a corresponding wooden block at
subframe or final drive (Fig. for vehicles with front wheel drive).
-
Tighten band around subframe or final drive.
Note:
^
If a front hydraulic bushing is to be replaced, only loosen front subframe bolts.
^
If a rear hydraulic bushing is to be replaced, only loosen rear subframe bolts.
^
If you loosen an additional front or rear subframe bolt, a vehicle alignment will be necessary after installation.
-
Loosen front or rear subframe bolts.
-
Carefully lower subframe approx. 5 cm.
-
Only remove subframe bolt where hydraulic mounting must be replaced.
-
Mark location of hydraulic mounting - 1 - to subframe - 2 -, e.g. with a felt-tip pen (Fig. shows subframe on front wheel drive vehicle).
Arrow A: Driving direction
Arrows B and C: Marking
-
Install special tools as shown in illustration.
1 - Nut T40034/1 or T40034/2
2 - Press piece T40033/1
3 - Support ring T40033/2