RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
/Page-2469001.png)
Ride Height Sensor: Procedures
Vehicle level sensor in vehicles with automatic headlight vertical aim control
Note:
^
General information
^
As a replacement part, vehicle level sensor is only available together with coupling rod and lower retaining plate. To remove it completely,
subframe must be removed.
^
Replacing with subframe installed.
^
Headlamp Range Control Module J431
1 - Combi-bolt
^
Always replace
^
Tighten to 85 Nm plus an additional 90 degrees turn
2 - Left Rear Level Control System Sensor G76 or G77 Right Rear Level Control System Sensor G77
^
Complete with components
^
Lever - arrow - must face toward center of vehicle
^
Replace in vehicle
^
After replacing, perform headlight basic setting
3 - Collar bolt, 10 Nm
4 - Trapezoidal control arm
