RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
/Page-1423008.png)
-
If equipped, unclip Level Control System Sensor operating rod at lower control arm - arrow -.
-
Before loosening subframe, you must check whether Testing Mandrel (3393) can slide completely into holes - 1 - and - 2 - in subframe - arrow -.
CAUTION!
If this is not the case, vehicle alignment must be carried out after installing subframe.
-
First remove front bolts - 2 - and - 3 - at left and right subframe. Then remove bolts - 1 -.
