RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
Clutch Disc: Removal and Replacement
Clutch With SAC Pressure Plate (LUK Version), Servicing
Clutch with SAC pressure plate (LuK version), servicing - 6 Spd. Manual Transmission 0A3 All Wheel Drive
Note:
^
"SAC" stands for "Self-Adjusting Clutch".
-
Please refer to notes.
-
The transmission has to be removed before working on the clutch.
1 - Dual-mass flywheel
^
Ensure that dowel pins fit tightly
^
Contact surface for clutch lining must be free of grooves, oil and grease
^
Observe instructions for removal
2 - Needle bearing
3 - Bolt for flywheel
^
Replace
^
Bolt length: 22.5 mm; 60 Nm + 90 degrees further
^
Bolt length: 43 mm; 60 Nm + 180 degrees further
^
Observe instructions for removal
4 - Clutch plate
^
Installation position: Clutch lining must make full contact with flywheel