RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
-
Tighten bolts - arrows - of front driveshaft to tightening torque.
-
Remove alignment fixture 3139.
Audi A4, Audi Cabriolet:
-
Remove mounting bolts - arrows -. When doing this, driveshaft must be supported by a second technician.
-
Insert heat shield - 2 -. Continue to support driveshaft while doing this.
-
Install mounting bolts - 4 - on left and right a few more turns.
-
Secure heat shield - 2 - on left and right with a bolt - 1 - (M8x30) on intermediate bearing - 3 -.
Note:
^
When tightening the combination bolt - 4 -, make sure that centering element - arrow A - is located in the locating hole - arrow B -.