RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
-
Position CV Joint Boot Clamp Tool VAG 1682 as shown in illustration. Make sure that the jaws of tension clamp seat in corners - arrows B - of
hose clip.
-
Tighten hose tie by turning spindle using a torque wrench (do not bend tensioning clamp).
^
Torque specification: 20 Nm
^
Use torque wrench with a range of 5 to 50 Nm (e.g. torque wrench V.A.G 1331).
^
Ensure the spindle thread is not tight. If necessary lubricate with MOS 2 grease.
^
If the thread is tight e.g. dirty, the required tensioning force for the hose clamp will not be achieved in spite of correct torque specification settings.