RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
-
Secure CV joint from coming apart, e.g. with adhesive tape - arrow -.
-
Press off CV joint.
Note:
^
Position ball hub with chamfer on inner diameter (splines) on drive axle.
Use special tool shown in illustration.
Press block 40-204 A and clamping surfaces on drive axle must be free of grease.
-
Install circlip
-
Press 35 g joint grease into joint through ball races.
-
Using bolts - arrows -, align protective boot and cap with screw holes.
It must be aligned exactly because it cannot be aligned after driving on.
-
Drive off protective boot with cap using plastic hammer.
-
Clear away leaking sealant immediately.
-
Align new cover with bolts - arrows - to screw holes.
It must be aligned exactly because it cannot be aligned after driving on.
-
Drive cover on with a plastic hammer.
-
Clear away leaking sealing immediately.