RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
Constant Velocity Joint: Overhaul
Triple Roller Joint AAR 2600 i or 3300 i, Disassembling
Triple roller joint AAR 2600 i or 3300 i, disassembling
Removal
-
Clamp drive axle horizontally in vise.
Note:
^
Use protective vise covers.
^
Ensure drive axle is not damaged.
-
Mark location of joint to drive axle
If parts are not marked when assembling, the components are not brought back to their previous installation position then it is possible that it will be
noisy when driving.
A waterproof felt tipped pen is suitable for marking.
-
Open clamps - arrows -.
-
Slide back protective boot.
Distinguishing characteristic of drive axle AAR 2600 i to AAR 3300 i
-
Determine dimension - A - as shown in illustration.
^
Dimension - A - 74 mm = driveshaft AAR 2600 i
^
Dimension - A - 77 mm = driveshaft AAR 3300 i
CAUTION!
Ensure correct special tool allocation for each drive axle.
-
Guide triple roller joint AAR 3300 i assembly device T40018 or triple roller joint AAR 2600 i assembly device T40084 behind joint.