RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
‹› Exterior diameter: 108 mm
‹› Replace only as complete unit
‹› Removing => [ Inner CV joint, removing ] See: Inner CV Joint, 108 mm Diameter, Servicing
‹› Installing => [ Inner CV joint, installing ] See: Inner CV Joint, 108 mm Diameter, Servicing
‹› Greasing
‹› Adhesive surface must be free of oil and grease
‹› Checking, refer to => [ Inner CV Joint, 108 mm Diameter, Checking ] See: Testing and Inspection/Front Suspension/Inner CV Joint, 108 mm
Diameter, Checking
‹› When installing joint on axle shaft, splines on axle shaft must be lightly coated with grease used in joint.
4 - Protective boot with cap
‹› in case of damage, check inner CV joint, refer to => [ Inner CV Joint, 108 mm Diameter, Checking ] See: Testing and Inspection/Front
Suspension/Inner CV Joint, 108 mm Diameter, Checking
‹› Check for tears and scuffing
‹› Replace only as complete unit
‹› Protective boot-driveshaft sealing surfaces and cap must be free of grease when installing
5 - Backing plate
6 - Socket head bolt
7 - Axle shaft
8 - Clamp
‹› Always replace
9 - CV boot for outer constant velocity (CV) joint
‹› Without ventilation bore
‹› Check for tears and chafing; replace if necessary.
‹› In case of damage, check outer CV joint, refer to => [ Outer CV Joint, 108 mm Diameter, Checking ] See: Testing and Inspection/Front
Suspension/Outer CV Joint, 108 mm Diameter, Checking
‹› Sealing surfaces must be free of grease when installing.
10 - Clamp
‹› Always replace
11 - Securing ring
‹› Always replace
‹› Installed position => [ Location of spacer and spring washer (wheel
side) ] See: Peened Triple Roller Joint AAR 2600 i or 3300 i Assembly Overview
12 - Dished washer
‹› Installed position => [ Location of spacer and spring washer (wheel
side) ] See: Peened Triple Roller Joint AAR 2600 i or 3300 i Assembly Overview