RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
Constant Velocity Joint: Removal and Replacement
Outer Constant Velocity Joint, 100 mm, Replacing
Outer Constant Velocity Joint, 100 mm, Replacing
Outer CV joint, removing
-
Drive axle, clamping in vise
Use protective vise covers for this.
-
Open clamps.
-
Slide back protective boot
-
Strike a copper or brass drift on CV joint inner race with a hammer
-
Remove joint
Outer CV joint, installing
-
Slide joint protective boot onto drive axle.
-
Insert new circlip
Circlip (snap ring) must be replaced
-
Apply 50 g joint grease in inside of joint.
-
Before installing joint or triple roller star, splines - A - must be lightly coated with grease used in joint.