RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
/Page-1562002.png)
‹› For the initial measurement, an adjustment shim "S2" with a thickness of 1.30 mm is inserted. It is designated as "S2* " in the following. After
determining backlash, "S2* " is replaced by final "S2".
-
Pressing outer race for tapered roller bearing without shim " S1" into final drive cover.
-
Insert differential into transmission housing. Ring gear is located on left side in front of final drive cover.
‹› O-ring is inserted in final drive cover.
-
Install transmission cover with 4 screws (24 Nm).
-
Turn transmission so that final drive cover faces upward.
-
Turn differential 5 turns in both directions so that the taper roller bearings settle.
-
Place magnetic plate (VW 385/17) on differential.
-
Assemble measuring tool, use 30 mm dial gauge extension.
