RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
/Page-1474002.png)
-
Thread puller T10037 tightly to housing - arrow - and pull out flange shaft.
Remove left drive flange
-
Place drip tray underneath.
-
Thread puller T10037 tightly to housing - arrow - and pull out flange shaft.
-
Pry out sealing ring with suitable lever.
Installing
Installation is in reverse order of removal. Note the following:
Installing right oil seal
-
Coat outer edge of gasket with axle oil.
-
Fill area between sealing lip and dust lip halfway with sealing grease G 052 128 A1.
