RS 4 Quattro Sedan V8-4.2L (BNS) (2007)
Hood Latch Release Cable: Service and Repair
Hood Cable
Hood Cable
1
Hood cable
‹› Removing:
-
Remove front wheel housing liner => [ Front Wheel housing Liner ] See: Fender/Front Fender/Front Fender Liner/Service and Repair.
-
Remove storage compartment on driver's side (vehicles with knee bolster):
-
Remove bolt => [ (Item 3) Screw ].
-
Remove retaining clip => [ (Item 4) Retaining clamp ].
-
Unclip cable for lower part of hood lock and disengage attachment lug - arrow A -.
-
Remove cable => [ (Item 1) Hood cable ] from retaining clips => [ (Item 6) Retaining clip ] opened earlier and pull into wheel housing toward
lock carrier.
‹› Install in reverse sequence.
‹› Bring ball on cable for lower part of hood lock into installation position.
2
Operating lever
3
Screw