RS 4 Quattro Sedan V8-4.2L (BNS) (2007)
/Page-944007.png)
CAUTION!
When installing, make sure that the cylinder head gaskets do not become damaged. A damaged cylinder head seal must be replaced.
-
Tighten the bolts in 6 steps as follows:
The rest of the installation is in reverse order of removal, note the following:
-
Install the transmission-side crankshaft shaft seal. Refer to => [ Crankshaft Seal, Transmission Side ] See: Seals and Gaskets/Crankshaft Main
Bearing Seal/Service and Repair.
-
Install oil filter housing => [ Oil Filter Housing ] See: Engine Lubrication/Oil Cooler/Service and Repair/Oil Filter Housing.
-
Install intake manifold.
-
Install left and right timing chain covers => [ Installing ] See: Left and Right Timing Chain Covers.
-
Install dual-mass flywheel. Refer to => [ Dual Mass Flywheel ] See: Transmission and Drivetrain/Flywheel/Service and Repair/Dual Mass
Flywheel.
-
Install clutch pressure plate.
-
After installing the engine, fill with oil and check the oil level.
