RS 4 Quattro Sedan V8-4.2L (BNS) (2007)
/Page-2337001.png)
Wiring Harness: Procedures
Contacts In Terminal Housing, Repairing
Contacts in Terminal Housing, Repairing
Procedure
-
First, open or release secondary lock of the contact housing (where applicable) => [ Terminal Housings ] See: Removal and
Replacement/Terminal Housings.
-
Release contact (primary lock) using appropriate release tool - A - => [ Terminal Housings ] See: Removal and Replacement/Terminal Housings.
-
Pull contact back out of housing - arrow - at single wire (with single wire seal if necessary).
-
Cut off old contact (with the single wire seal) from vehicle-specific wiring harness.
-
Determine yellow repair wire with correct contact from Wiring Harness Repair Set (VAS 1978A).
-
Free up wire to be repaired approximately 20 cm on both sides of the repair point.
CAUTION!
Risk of damaging the electrical wires.
‹› Free up wrapped wiring harnesses carefully.
-
If necessary, remove wiring harness wrapping using knife.
-
Slide new repair wire contact into corresponding contact housing compartment until it engages.
