RS 4 Quattro Sedan V8-4.2L (BNS) (2007)
-
Pull locking flange and sealing ring from opening of fuel tank.
-
Carefully pull locking flange - 1 - with fuel level sensor 2 G169 with suction jet pump - 2 - partially out of fuel tank opening.
NOTE: When removing, be sure not to bend floater arm of fuel level sensor 2 G169.
-
Unclip suction jet pump from locking flange with Fuel Level Sensor 2 G169.
-
Remove locking flange with fuel level sensor 2 G169.
Installing
Installation is in reverse order of removal. Note the following:
NOTE:
-
Replace seal.
-
When installing, be sure not to bend floater arm of fuel level sensor 2 G169.
-
Clip suction jet pump to locking flange so that it is audibly engaged.
-
Carefully insert Fuel Level Sensor 2 G169 into fuel tank opening.
-
Install new locking flange seal dry.
-
Press locking flange down against spring pressure and bring it into installation position.
-
Tab - 2 - on locking flange must lie between tabs - 1 - and - 3 - on fuel tank.
NOTE: - Arrow - points in direction of travel.
-
Tighten locking ring.
-
Connect battery. Observe safety precautions after connecting battery.