RS 4 Quattro Sedan V8-4.2L (BNS) (2007)
Clutch Switch: Service and Repair
Clutch Pedal Starter Interlock Switch F194, Removing and Installing
Clutch Pedal Starter Interlock Switch F194, removing and installing, 0A3, 6-Speed All Wheel Drive M/T
Note:
^
To ensure a secure fit, the Clutch Pedal Starter Interlock Switch F194 must not be installed more than once.
Removing
-
Remove storage compartment on drivers side.
-
Disconnect electrical connector - 3 - on clutch pedal switch for engine start.
-
Press clutch pedal - 1 - all the way down and hold it in this position.
-
At the same time, release Clutch Pedal Starter Interlock Switch F194 - 2 - by turning it 45° in the direction indicated - arrow - and pull it out of the
guide.
Installing
-
Pull out operating rod - arrow - all the way before installing clutch pedal switch.