RS 4 Quattro Sedan V8-4.2L (BNS) (2007)
/Page-2520009.png)
-
Insert new bolt - 2 - and self-locking nut and tighten
-
Insert fork-head suspension strut in control arm and hand tighten threaded connection - 1 -.
Bonded rubber bushings have a limited torsional range. Only tighten threaded connections at control arms if vehicle is in curb weight position. Refer
to => [ Wheel Bearing, Lifting to Curb Weight Position ] See: Suspension/Wheel Bearing/Service and Repair/Procedures/Rear Suspension
-
Insert tie rod in steering arm to stop.
‹› Install tie rod in steering arm - 1 - only by hand and do not stress tie rod end seal - 2 - when doing so.
