RS 4 Quattro Sedan V8-4.2L (BNS) (2007)
/Page-1623003.png)
-
Remove inner CV joint protective boot from drive axle.
Inner CV joint, installing
-
Apply sealant - hatched surface - to clean surface on inner side of protective joint boot cap. Sealant bead: unbroken, 2 to 3 mm in dia. Skirt area
around inner holes - arrow -.
-
Use sealant D 454 300 A2 for this
-
Slide joint protective boot onto drive axle.
-
Before installing joint or triple roller star, splines - A - must be lightly coated with grease used in joint.
