RS 6 V8-4.2L Turbo (BCY) (2003)
-
Remove metal disk - 10 - from rear cut-out of D-pillar trim panel - 1 - for grab handle using a small screwdriver
-
Using a flat-headed screwdriver, pull out wire cable - 9 - at metal disc - 10 - (toward B-pillar, pull hard, about 40 mm) until D-pillar trim -
1 - disengages audibly.
NOTE: When removing D-pillar trim - 1 -, touch only side facing headliner or rear windshield.
-
Remove trim - 1 - from clip - 7 - by moving back and forth lightly.
-
Unclip trim from D-pillar - 5 -.