RS 6 V8-4.2L Turbo (BCY) (2003)
Brake Caliper: Service and Repair
Rear Brake Calipers (C43), Servicing
Brake caliper, servicing
Rear brakes with automatic adjustment
Note:
^
Always install the complete repair kit.
^
After replacing brake pads and before moving vehicle, depress brake pedal several times firmly to properly seat brake pads in their normal
operating position.
^
When siphoning brake Fluid, always use a bleeder bottle that is used exclusively for brake Fluid. Brake Fluid is poisonous. NEVER siphon brake
Fluid with your mouth!
^
Brakes can be tested on all normal commercial test equipment, provided the two brake test rollers are not driven faster than 5.5 km/in.
1. Hex bolt, self-locking, 35 Nm
^
Always replace
^
When loosening and tightening counter hold on guide pin
2. Brake caliper housing
^
Unbolt caliper housing when changing brake pads
^
Hose must not be twisted when installed
^
Do not disconnect brake hose when changing brake pads
3. Brake pads
^
If required, always renew both sides together
^
Do not disconnect brake hose when changing brake pads
^
Checking thickness: Refer to specifications.
4. Pad retaining spring
^
Always replace when changing pads
5. Brake disc
^
If required, always replace both sides together
^
Remove brake caliper prior to removing
^
Lightly coat contact surfaces between brake disc and wheel hub with polycarbamide grease G 052 142 A2