RS 6 V8-4.2L Turbo (BCY) (2003)
/Page-1603002.png)
-
Unscrew bolts and nuts -1- to -6-.
-
Detach retaining clamps for turbocharger coolant pipes from studs and press pipes down with light pressure.
-
Take out rear coolant pipe.
Installing
Install in reverse sequence; note following points:
Note:
^
Replace O-rings.
^
Secure all hose connections with correct hose clamps (same as original equipment), Refer to Part Supplier.
-
Before installing, clean and smooth down sealing surfaces for O-rings as required.
-
Install engine
Tightening torques
