RS 6 V8-4.2L Turbo (BCY) (2003)
Oil Filter Adapter: Service and Repair
Oil Filter Bracket With Oil Cooler, Removing and Installing
Oil filter bracket with oil cooler, removing and installing
Special tools and equipment
^
Drip tray
Removing
-
Remove engine.
-
Remove right front exhaust pipe.
-
Remove right exhaust manifold.
-
Remove coolant pipe going to oil filter bracket.
-
Place a drip tray underneath.
-
Remove oil filter.
-
Take out bolts -1- to -5- and remove oil filter bracket with oil cooler from cylinder block.
Installing
Install in reverse sequence; note following points-
Note: Replace seals and O-rings.
-
Make sure dowel sleeves are seated when installing.
-
Install center pipe -item 22.
-
Tighten oil filter bracket bolts -1- to -5- alternately and diagonally.
-
Install coolant pipe going to oil filter bracket.
Tightening torques