RS 6 V8-4.2L Turbo (BCY) (2003)
Liquid Vapor Separator: Locations
Fuel Filler Neck With Expansion Tank, Component Overview -vehicles With 8-Cylinder Engine Except A6 Allroad
WARNING: Fire hazard. When working on the fuel system DO NOT smoke, work near heaters or have anything in the area that can ignite the fuel or
fumes.
1
Heat shield
-
For fuel filler neck
2
Vent line
-
To EVAP canister
3
Hose connection
-
For fuel filler pipe
4
Vent line
-
To fuel tank front top right
5
Vent line
-
From fuel tank front left
6
Vent line
-
From fuel tank left rear
7
Vent line
-
From fuel tank right rear
8
Ground (GND) wire
-
To deter static electricity. Installation position/Checking procedure, see Fig. 1
-
Make sure tight fit of connector and fasten wire with bolt for fuel filler neck -item 16-
-
After installing, measure resistance using multimeter (Fluke 83 or equivalent) between metal ring of fuel filler neck and bare metal part of
body. Specified value: approx. 0 Ohms
CAUTION: After installing, measure the resistance using a multimeter (Fluke 83 or equivalent) between the metal ring of the fuel filler neck and a bare
metal part of the body. Specified value: approx. 0 Ohms
9
Rubber cup