RS 6 V8-4.2L Turbo (BCY) (2003)
EGR Temperature Sensor: Service and Repair
Exhaust gas temperature sensor, removing and installing
Removing
Note: All cable ties which are released or cut open when removing must be installed in same position when installing.
-
Remove engine
-
Unplug connector for exhaust gas temperature sensor.
-
Move line to exhaust gas temperature sensor clear.
-
Remove temperature sensor of exhaust gas temperature sensor -3-.
Note:
^
Illustration shows left temperature sensor.
^
Items -I- and -2- remain installed.
Installing
Install in reverse sequence; note following points:
Note: All cable ties which are released or cut open when removing must be installed in same position when installing.
-
Connection of temperature sensor for exhaust gas temperature sensor must face downward when installing. Guide line upward in a loop.
-
Install engine1
Tightening torque